Cisco ONS 15454 SDH - Perform a Hairpin Test on a Destination-Node Electrical Port (East to West)

xxviii
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
About this Guide
Document Objectives
This guide covers the software features and operations of Ethernet cards for the Cisco ONS 15454 and
Cisco ONS 15454 SDH. It explains software features and configuration for Cisco IOS on the ML-Series
card. The ML-Series card is a module in the Cisco ONS 15454 SONET or Cisco ONS 15454 SDH
system. It also explains software feature and configuration for CTC on the E-Series, G-Series and
CE-Series cards. The E-Series cards and G-Series cards are modules in the Cisco ONS 15454 and Cisco
ONS 15454 SDH. The CE-Series cards are modules in the Cisco ONS 15454. The CE-100T-8 is also
available as module for the Cisco ONS 15310-CL. The Cisco ONS 15310-CL version of the card is
covered in the Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and
Configuration Guide. Use this guide in conjunction with the appropriate publications listed in the
Related Documentation section.
July 2008 Updated section “Flow Control Pause and QoS” of the Ingress Priority Marking
Topic in Chapter 14, Configuring Quality of Service.
August 2008 Reference to Auto-MDIX is removed from the following sections:
• Configuring the Fast Ethernet Interfaces for the ML100X-8 section of
Chapter 6, Configuring Interfaces
• ML-Series Feature List section of Chapter 1, ML-Series Card Overview
September 2008 Corrected the footnote of Table 5-1 in Chapter 5, Configuring POS.
January 2009
• Added the following sections in Chapter 14, Configuring Quality of Service:
– QoS not Configured on Egress
– ML-Series Egress Bandwidth Example
• Added a new bullet point in the “IP SLA Restrictions on the ML-Series”
section.
May 2009 Added a note to the section, EoMPLS Configuration on PE-CLE SPR Interface in
the chapter, Configuring Ethernet over MPLS.
October 2009 Deleted the following caution from Chapter 4, “Configuring Interfaces”:
• Do not use the abbreviations g0 or g1 for Gigabit Ethernet user-defined
abbreviations. This creates an unsupported group asynchronous interface.
February 2010 Updated image in the chapter, “Configuring VRF Lite”.
September 2010 Updated the Example 15-1 Limiting the IP-Prefix Region to 2K Entries.
March 2011
• Updated the section “Flow Control Threshold Provisioning” in the chapter
“CE-1000-4 Ethernet Operation”.
• Updated the section “IEEE 802.3z Flow Control and Frame Buffering” in the
chapter “E-Series and G-Series Ethernet Operation”.
August 2012 The full length book-PDF was generated.
Date Notes