A-29
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
rpr-ieee tx-traffic rate-limit high rate [east | west]
rpr-ieee tx-traffic rate-limit high rate [east | west]
Use this command to limit the rate at which Class A1 traffic is transmitted only on a specific (east or
west) span.
Syntax Description
Defaults The default is 5 Mbps.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines Class A1 traffic is used for latency-sensitive traffic, such as voice traffic, that should run at a low rate.
This command allows you to control the traffic on a specific span. It applies to only one span. Specifying
the span might not be necessary in all cases.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee tx-traffic rate-limit high 10 east
Related Commands rpr-ieee tx-traffic strict
rpr-ieee tx-traffic rate-limit medium [east | west]
rpr-ieee tx-traffic rate-limit low [east | west]
Parameter Description
east Pertains to configuration for eastbound span traffic.
west Pertains to configuration for westbound span traffic.
rate Value, expressed in Mbps, of the maximum rate a station can use to transmit
Class A1 traffic onto a particular (east or west) span. (Class A1 traffic is the
Class A traffic in excess of A0.) The rate range is 0 to 1161 Mbps.
To Next Page
Loading...
