Cisco ONS 15454 SDH - Page 506

A-30
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
rpr-ieee tx-traffic rate-limit medium rate [east | west]
rpr-ieee tx-traffic rate-limit medium rate [east | west]
Use this command to limit the rate that Class B-CIR traffic is transmitted on a specific (east or west)
span.
Syntax Description
Defaults The default is 5 Mbps.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines This command is used for adding Class B traffic to a specific span. Traffic added at or below the
configured rate (for example, at or below 5 Mbps) is Class B-CIR traffic and is not fairness-eligible.
Traffic added above the configured rate (for example, above 5 Mbps) is set as class B-EIR traffic and is
fairness-eligible. This command is specific to one span and would only be used if necessary to make this
distinction.
Examples In this example, interface is shortened to int.
router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee tx-traffic rate-limit medium 2 east
Related Commands rpr-ieee tx-traffic rate-limit low [rate] {east | west}
rpr-ieee tx-traffic rate-limit high [rate] {east | west}
rpr-ieee tx-traffic rate-limit reserved
Parameter Description
east Pertains to configuration for eastbound span traffic.
west Pertains to configuration for westbound span traffic.
rate Value, expressed in Mbps, of the maximum rate a station can use to transmit
Class B-CIR traffic onto a particular (east or west) span. The rate range is
0 to 1161 Mbps.