A-56
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
show ons alarm failure pos interface-number
show ons alarm failure pos interface-number
Use this command to display the link-layer failures.
Syntax Description
Defaults N/A
Command Modes Privileged exec
Usage Guidelines This command displays the set of active failures for a specific interface at the POS layer. The display
also specifies if an alarm has been demoted, as defined in Telcordia GR-253.
Examples
router# show ons alarm failure pos 0
POS0
Active Alarms : None
Demoted Alarms: None
Related Commands show controller pos
show ons alarm defect
Parameter Description
interface-number Number of the interface (0–1)
To Next Page
Loading...
