A-80
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
spr-intf-id shared-packet-ring-number
spr-intf-id shared-packet-ring-number
Use this command to assign the POS interface to the SPR interface.
Syntax Description
Defaults N/A
Command Modes POS interface configuration
Usage Guidelines
•
The SPR number must be 1, which is the same SPR number assigned to the SPR interface.
•
The members of the SPR interface must be POS interfaces.
•
An SPR interface is configured similarly to a EtherChannel (port-channel) interface. Instead of
using the channel-group command to define the members, you use the spr-intf-ID command. Like
port-channel, you then configure the SPR interfaces instead of the POS interface.
Note
A similar command, the spr drpri-id [0 | 1] command, is not supported in R7.2.
Examples In this example, interface is shortened to int. An ML-Series card POS interface is being assigned to an
SPR interface with a shared-packet-ring-number of 1:
Router(config)# interface pos 0
Router(config-if)# spr-intf-id 1
Related Commands interface spr 1
spr station-id
spr wrap
Parameter Description
shared-packet-ring-number The only valid shared-packet-ring-number (SPR number) is 1.
To Next Page
Loading...
