Configuring SNMP
SNMP Notification Filters
Cisco Small Business 300 Series Managed Switch Administration Guide 294
19
SNMP Notification Filters
The
Notification Filter Page
enables configuring SNMP notification filters and
Object IDs (OIDs) that are checked. After creating a notification filter, it is possible
to attach it to a notification recipient in the SNMPv1,2 Notification Recipient Page,
and
SNMP v3 Notification Recipient page
.
The notification filter enables filtering the type of SNMP notifications that are sent
to the management station based on the OID of the notification to be sent.
To define a notification filter:
STEP 1 Click SNMP > Notification Filter. The
Notification Filter Page
opens.
The
Notification Filter Page
displays notification information for each filter. The
table is able to filter notification entries by Filter Name.
STEP 2 Click Add. The
Add Notification Filter Page
opens.
STEP 3 Enter the parameters.
• Filter Name—Enter a name.
• Object ID Subtree—Select the node in the MIB tree that is included or
excluded in the selected SNMP view. The options are:
- Select from List—Enables you to navigate the MIB tree. Click Up to go to
the level of the selected node's father and siblings. Click Down to
descend to the level of the selected node's descendents. Click the nodes
in the view to pass from one node to its brother. Use the scrollbar to bring
siblings into view.
- Object ID—Enter an OID not offered in the Select from List option (if
required). All descendents of this node are included or excluded in the
view.
- If Select from list is used, the object identifier of the selected node is
included in or excluded from the view if the Include in filter option is
selected.
- If Object ID is used, the entered object identifier is included in or
excluded from the view if the Include in filter option is selected.
To Next Page
Loading...
