Do not mix power supply types in the server. Both power supplies must be identical.
Note
770-WAC Power Supply
SpecificationDescription
90 to 264 VAC (self-ranging, 100 to 264 VAC
nominal)
AC input voltage range
Range: 47 to 63 Hz (single phase, 50 to 60 Hz
nominal)
AC input frequency
9.5 A peak at 100 VAC
4.5 A peak at 208 VAC
AC line input current (steady state)
770 WMaximum output power for each power supply
Main power: 12 VDC
Standby power: 12 VDC
Power supply output voltage
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware
Appliances
This section describes how to install your Cisco SNS 3515 or 3595 appliance and connect it to the network.
It contains:
• Install the Cisco SNS 3515 or 3595 Appliance in a Rack, on page 15
• Cisco Integrated Management Controller, on page 24
• Connect Cables, on page 19
• Connect and Power On the Cisco SNS 3515 or 3595 Appliance, on page 22
Before you begin the installation, read the Regulatory Compliance and Safety Information for the Cisco SNS
3515 or Cisco SNS 3595 Hardware Appliance.
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Install Cisco ISE Software on Cisco SNS Appliances
14
Install Cisco ISE Software on Cisco SNS Appliances
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
To Next Page
Loading...
Need help?
General