Step 3 From the Boot Menu, choose the USB as the boot device and press Enter.
Use the arrow keys to select the USB boot device.
Step 4 At the boot prompt, choose one of the following and press Enter.
• Cisco ISE Installation (Serial Console) to install Cisco ISE through a serial console
• Cisco ISE Installation (Keyboard/Monitor) to install Cisco ISE using a keyboard and monitor.
Example:
Figure 12: Boot Prompt
Step 5 After you enter the network configuration parameters in Setup mode, the appliance automatically reboots and returns to
the shell prompt mode.
Step 6 Exit from the shell prompt mode. The appliance comes up.
Step 7 Continue with Verify the Installation Process, on page 35.
Create a Bootable USB Device to Install Cisco ISE
Use the Fedora Media Writer (formerly Fedora Live USB Creator) tool to create a bootable USB device from
the Cisco ISE installation ISO file.
Before you begin
• Download Fedora Media Writer to the local system from the following location: https://github.com/
lmacken/liveusb-creator/releases/tag/3.12.0
Other USB tools might work, but we recommend that you use Fedora Media
Writer 3.12.0 as it has been tested with Cisco ISE.
Note
• Download the Cisco ISE installation ISO file to the local system.
• Use an 8-GB (or higher) USB device.
Install Cisco ISE Software on Cisco SNS Appliances
31
Install Cisco ISE Software on Cisco SNS Appliances
Create a Bootable USB Device to Install Cisco ISE
To Next Page
Loading...
Need help?
General