Cisco SNS 3400 Series - Page 6

USB 3.0 ports (two)8
The following table describes the LEDs located on the back panel of the Cisco SNS 3515 or Cisco SNS 3595
appliance.
StateLED Name
• Off—No link is present.
• Green, steady—Link is active.
• Green, blinking—Traffic is present on the active
link.
Optional mLOM 1-GbE SFP+ (there is a single status
LED)
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps/1 Gbps.
• Green—Link speed is 10 Gbps.
Optional mLOM 1-GbE BASE-T link speed
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
Optional mLOM 1-GbE BASE-T link status
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps.
• Green—Link speed is 1 Gbps.
1-GbE Ethernet dedicated management link speed
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
1-GbE Ethernet dedicated management link status
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps.
• Green—Link speed is 1 Gbps.
1-GbE Ethernet link speed
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
1-GbE Ethernet link status
• Off—The unit identification LED is not in use.
• Blue—The unit identification LED is activated.
Rear unit identification
Install Cisco ISE Software on Cisco SNS Appliances
6
Install Cisco ISE Software on Cisco SNS Appliances
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View