Cisco SPA100 Series Provisioning Guide

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 122
6
<VoIP_User_1_Auth_ID_3_> through
<VoIP_User_8_Auth_ID_3_>
A user ID that a VoIP Caller can use for authentication by using
the HTTP Digest method (in other words, by embedding an
Authorization header in the SIP INVITE message sent to the
ATA. If the credentials are missing or incorrect, the ATA will
challenge the caller with a 401 response). The VoIP caller
whose authentication user-id equals to this ID is referred to
VoIP User 1 of this ATA.
NOTE: If the caller specifies an authentication user-id that
does not match any of the VoIP User Auth ID’s, the INVITE will
be rejected with a 403 response.
Default setting: blank.
<VoIP_User_1_Password_3_> through
<VoIP_User_8_Password_3_>
The password to be used with VoIP User 1. The user assumes
the identity of VoIP User 1 must therefore compute the
credentials using this password, or the INVITE will be
challenged with a 401 response
Default setting: blank.
<VoIP_User_1_DP_3_>through <VoIP_
User_8_DP_3_>
For up to 8 VoIP users, specify the index of the dial plan to be
used after successful authentication. If authentication is
disabled, the default dial plan is used for all unknown VoIP
users.
Default setting: 1.
<PSTN-To-VoIP_Gateway_Enable_3_> Select yes to enable or select no to disable PSTN-To-VoIP
Gateway functionality.
Default setting: yes
<PSTN_Caller_Auth_Method_3_> The method to authenticate a PSTN Caller to access the VoIP
gateway. Choose from none or PIN.
Default setting: none
<PSTN_Ring_Thru_1_3_> To enable ring through to Line 1 based on caller number
patterns, choose yes. Otherwise choose no.
Note: For more information about PSTN Caller number
patterns, see <PSTN_Caller_ID_Pattern_3_>.
Default setting: yes

Cisco SPA100 Series Specifications

General

Brand	Cisco
Model	SPA100 Series
Category	Adapter
Language	English