Cisco SPA100 Series Provisioning Guide

Router Configuration Parameters
<MAC_Address_Clone> Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 157
7
<MAC_Address_Clone> Parameters
This section describes the parameters in the <MAC_Address_Clone> section of
the config.xml file.
TIP: You can click the <MAC_Address_Clone> heading in the XML file to expand
or collapse the nested parameters in this section.
NOTE In addition to the descriptions, also refer to<MAC_Address_Clone> Example:
MAC Address Clone enabled, page 158.
Parameter Details
<MAC_Address_Clone_Enabled> Description: Enables or disables MAC address cloning.
User Interface: Interface Setup > Advanced Settings > MAC
Address Clone page, MAC Clone field
Values:
0: Disabled
1: Enabled
Default: 0
Example: MAC clone enabled
<MAC_Address_Clone_Enabled>1</MAC_Address_Clone_Enabled>
<MAC_Address_Clone_Address> Description: MAC address to assign (clone) to this ATA
User Interface: Interface Setup > Advanced Settings > MAC
Address Clone page, MAC Address field (available when MAC
Clone is enabled)
Values: MAC address
Default: null
Example:
<MAC_Address_Clone_Address>00:22:68:19:EF:83</MAC_Address_
Clone_Address>

Cisco SPA100 Series Specifications

General

Brand	Cisco
Model	SPA100 Series
Category	Adapter
Language	English