Provisioning Parameters
Internal Error Codes
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 80
5
Internal Error Codes
The ATA defines a number of internal error codes (X00–X99) to facilitate
configuration in providing finer control over the behavior of the unit under certain
error conditions.
UID1 The contents of the Line 1 User_ID configuration
parameter (Firmware 2.0.11 and above).
UID2 The contents of the Line 2 User_ID configuration
parameter (Firmware 2.0.11 and above).
ISCUST Value=1 if unit is customized, 0 otherwise;
customization status viewable on WebUI Info page.
Parameter Name Description and Default Value
Parameter Name Description and Default Value
X00 Transport layer (or ICMP) error when sending a SIP
request.
X20 SIP request times out while waiting for a response.
X40 General SIP protocol error (for example, unacceptable
codec in SDP in 200 and ACK messages, or times out
while waiting for ACK).
X60 Dialed number invalid according to given dial plan.
To Next Page
Loading...
Need help?
General
