Cisco SPA100 Series Provisioning Guide

Provisioning Parameters
Configuration Profile Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 71
5
Resync_Error_Retry_Delay Resync retry interval (in seconds) applied in
case of resync failure.
The device has an error retry timer that
activates if the previous attempt to sync
with the provisioning server fails. The
device waits to contact the server again
until the timer counts down to zero.
This parameter is the value that is initially
loaded into the error retry timer. If this
parameter is set to zero, the device
immediately retries to sync with the
provisioning server following a failed
attempt.
The default value is 3600 seconds.
Forced_Resync_Delay Maximum delay (in seconds) the ATA waits
before performing a resync.
The device does not resync while one of its
phone lines is active. Because a resync can
take several seconds, it is desirable to wait
until the device has been idle for an
extended period before resyncing. This
allows a user to make calls in succession
without interruption.
The device has a timer that begins counting
down when all of its lines become idle. This
parameter is the initial value of the counter.
Resync events are delayed until this counter
decrements to zero.
The default value is 14,400 seconds.
Resync_From_SIP Enables a resync to be triggered via a SIP
NOTIFY message.
The default value is Yes.
Resync_After_Upgrade_Attempt Triggers a resync after every firmware
upgrade attempt.
The default value is Yes.
Parameter Name Description and Default Value

Cisco SPA100 Series Specifications

General

Brand	Cisco
Model	SPA100 Series
Category	Adapter
Language	English