Cisco SPA100 Series Provisioning Guide

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 83
6
<Resync_At_HHmm> The time of day when the device tries to resync. The resync is
performed each day. Used in conjunction with the Resync At
Random Delay.
Default setting: blank
<Resync_At_Random_Delay> Used in conjunction with the Resync At (HHmm) setting, this
parameter sets a range of possible values for the resync
delay. The system randomly chooses a value from this range
and waits the specified number of seconds before attempting
to resync. This feature is intended to prevent the network jam
that would occur if all resynchronizing devices began the
resync at the exact same time of day.
Default setting: 600
<Resync_Periodic> The time interval between periodic resyncs with the
provisioning server. The associated resync timer is active only
after the first successful synchronization with the server.
Setting this parameter to zero disables periodic
resynchronization.
Default setting: 3600 seconds
<Resync_Error_Retry_Delay> Resync retry interval (in seconds) applied in case of resync
failure.
The ATA has an error retry timer that activates if the previous
attempt to sync with the provisioning server fails. The ATA
waits to contact the server again until the timer counts down
to zero.
This parameter is the value that is initially loaded into the error
retry timer. If this parameter is set to zero, the ATA
immediately retries to sync with the provisioning server
following a failed attempt.
Default setting: 3600 seconds

Cisco SPA100 Series Specifications

General

Brand	Cisco
Model	SPA100 Series
Category	Adapter
Language	English