Cisco Stealthwatch - Page 81

l
eth2
l
port channel containing eth2 and eth3
You must assign non-routable IPaddresses from the 169.254.42.0/24
CIDRblock.
Before You Begin
l
See the Stealthwatch specification sheet for your appliance for information on
the eth2 and eth3 SFP+ports. Note that eth2 and eth3 depend on how you
configure eth0.
l
If you are in First Time Setup, System Configuration displays the eth2 or
eth2/eth3 port channel configuration after you finish configuring the appliance's
eth0 management information. Skip to step 3.
Procedure
1. From the System Configuration menu, select Network, and then press Enter.
2. Select Node Communications, and then press Enter.
3.
Select the inter-Data Node communication port configuration. You have the
following options:
l
Select Yes to aggregate eth2 and eth3 as a port channel for inter-Data
Node communications.
l
Select No to use eth2 for inter-Data Node communications.
4.
Enter a non-routable IPaddress from the 169.254.42.0/24 CIDRblock for
eth2 or the eth2/eth3 port channel.
5.
Enter a Netmask of 255.255.255.0 for this IP address.
6. Enter a Gateway address for this IPaddress.
7. Enter a Broadcast address for this IPaddress.
8. Select Select, then select Yes to confirm your entries.
This is the last configuration option in First Time Setup. Your appliance restarts
and implements the changes. On completion, the Login page opens.
What to Do Next
l
Change user passwords. See Changing the Sysadmin User Password for more
information.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 81 -
Appendix B.Stealthwatch Hardware Installation