Cisco Stealthwatch User Manual

l If you are configuring a Data Node, after you configure Port Order, the First Time
Setup wizard displays the eth0 management configuration. Go to step 3.
Procedure
1.
Log in to the System Configuration program:
l
If you are configuring a Data Node, type root, and then press Enter.
root permissions are required to properly configure the Data Store
and Data Store compatibility.
l
When the password prompt appears, type lan1cope, and then press Enter.
l
At the next prompt, type SystemConfig, and then press Enter.
2.
If this is the first time you entered System Configuration on this appliance, First
Time Setup starts.
Otherwise, the System Configuration menu opens. Select Management, and
then press Enter.
3. Enter an IPaddress for this appliance.
4. Enter a Netmask for the network.
5. Enter a Gateway address for this appliance's IPaddress.
6. Enter a Broadcast address for the appliance.
7. Enter a Hostname for your appliance.
8. Enter a Domain for your appliance.
9. Select Select, then select Yes to confirm your entries.
What to Do Next
l Configure the Data Node communication port management information. See
Configure eth2 and eth3 for inter-Data Node communications: for more
information.
Configure eth2 and eth3 for inter-Data Node com-
munications:
When configuring a Data Node appliance, configure the inter-Data Node communication
port with a non-routable IPaddress. You can configure one of the following:
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 80 -
Appendix B.Stealthwatch Hardware Installation

Cisco Stealthwatch Specifications

General

Brand	Cisco
Model	Stealthwatch
Category	Storage
Language	English