Cisco TelePresence MX200 G2 User Manual

22
D1534504 User Guide
Cisco TelePresence
Produced: November 2016 for CE 8.2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
Call Rate
Change Call Rate
Finally, change the call rate by
moving the slider.
This can only be done before you call
someone.
Tap More (
) to gain access to the
options.
Then tap Call Rate.
Call rate is the term used to express
the amount of bandwidth allocated
to the call and is measured in kbps
(kilobits per second).
The higher the call rate is, the
better the quality will be, but on
the expense of higher bandwidth
consumption.
The system comes with a default
call rate. This is set by your video
support team as a part of the
Administrator Settings (password
protected).
Why would you like to temporarily
change this setting? In most cases
you will use it to avoid choking
the video call when you try to call
someone at a higher rate than their
system and connection support.
Call rate cannot be changed during
a call, but you may change it just
before you place a call, as outlined
here.
About Call Rate

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30