Cisco TelePresence MX200 G2 User Manual

52
D1534504 User Guide
Cisco TelePresence
Produced: November 2016 for CE 8.2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
Add Camera Position Preset
Tap Camera to invoke the
camera adjustment menu.
Adjust Tilt, Pan and Zoom, as
required.
Tap Selfview to activate it.
Tap Add New.
Key in
a descriptive name.
Tap Save to leave
the menu putting
changes into eect,
or tap Cancel to
leave menu undoing
any changes.
About Camera Presets
Your video system lets you create
predened zoom and camera
pointing directions (also known as
pan and tilt). Use these to zoom into
the person speaking, if appropriate.
Do not forget to zoom out again
afterwards.
This means that if you want to create
one or more zoom-in presets you
should also create a zoom-out
(overview) preset to conveniently
switch back to overview mode.
Although you may control the far end
camera, i.e. the camera of any of the
other participants (given that those
cameras are remotely controllable),
you cannot dene nor make use of
their presets.
Camera
Pan
Tilt
Zoom

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30