Cisco TelePresence MX200 G2 User Manual

78
D1534504 User Guide
Cisco TelePresence
Produced: November 2016 for CE 8.2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
There are basically two modes of
video conferencing; viz. MultiWay
and MultiSite.
•
To enable MultiWay, a MultiWay
address must have been entered.
•
If a MultiWay address has been
specied and MultiWay is selected,
MultiWay will always be used for
video conferencing.
•
If a MultiWay address has been
specied, but MultiSite is selected,
MultiSite will be used.
•
If set to Auto, MultiWay will be
used if a MultiWay address
has been specied, otherwise
MultiSite will be used.
•
If set to O, no video conferencing
will be possible.
•
Any use of the MultiSite feature
requires the presence of the
MultiSite option.
Caution! There is no Cancel
function letting you exit the menu
undoing any changes you have
made. Take care!
Settings
Administrator Settings—Multipoint Mode
About Multipoint
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30