Cisco TelePresence MX700 Administrator's Guide

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
41
Cisco TelePresence MX700 and MX800 Administrator Guide
i
ii
iii
Managing the list of trusted
certificate authorities
As from software version TC7.2, the signature of an
audit server is verified using the same CA list as other
servers/clients.
Setting up secure audit logging
Audit logging records all sign in activity and configuration
changes on your video system.
Audit logging is disabled by default, but you can enable it
using the Security > Audit > Logging > Mode setting.
In ExternalSecure audit logging mode the video system
sends encrypted audit logs to an external audit server
(syslog server), which identity must be verified by a signed
certificate.
If the audit server cannot be authenticated, the logs will not
be sent.
Always upload the list of trusted certificate authorities
before enabling secure audit logging.
Enable secure audit logging
i. Go to the System
Configuration page and
choose the Security
category.
ii. Enter the Address of
the audit server. If
you choose Manual
PortAssignment, you
must also enter a Port
number for the audit
server. Click Save for the
changes to take effect.
iii. Choose ExternalSecure
from the Logging Mode
drop-down list. Click
Save for the change to
take effect.
Navigate to: Configuration > Security: CAs tab / Configuration > System Configuration
(page 2 of 2)
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
Web interface

Cisco TelePresence MX700 Specifications

General

Product Type	Video conferencing system
Frame Rate	Up to 60 fps
Display	Dual 55-inch LCD
Audio	Integrated speakers and microphones
Video Standards	H.264
Network	Ethernet
Connectivity	HDMI, USB
Control	Touch 10 control unit
Video Resolution	1080p at 60 fps
Zoom	12x optical zoom
Codec	H.264
Network Protocols	SIP
Power Consumption	300W
Weight	90 kg