Cisco TelePresence MX700 Administrator's Guide

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
42
Cisco TelePresence MX700 and MX800 Administrator Guide
Managing pre-installed certificates
for Edge provisioning
The list of pre-installed certificates that is shown on this
page in the web interface
*
, contains certificates that will be
used when the video system is provisioned by Cisco Unified
Communications Manager (CUCM) via Expressway (Edge).
Only Edge infrastructure certificates will be checked against
this list.
If the Edge infrastructure certificate validation fails, the video
system will not receive the provisioning and not be registered.
Factory resetting the video system will not delete the list of
pre-installed certificates.
Navigate to: Configuration > Security: Preinstalled CAs tab
*
The certificate and certificate issuers shown in the illustration serve
as examples. Your system will have other certificate(s).
Viewing or disabling certificates
You can view a certificate, and
disable a certificate using the
corresponding buttons.
You can disable all the pre-
installed certificates, and use
a manually uploaded list of
certificates for verification instead.
See the Configuration > Security:
CAs page how to upload trusted
certificates to the video system
manually.
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
Web interface

Cisco TelePresence MX700 Specifications

General

Product Type	Video conferencing system
Frame Rate	Up to 60 fps
Display	Dual 55-inch LCD
Audio	Integrated speakers and microphones
Video Standards	H.264
Network	Ethernet
Connectivity	HDMI, USB
Control	Touch 10 control unit
Video Resolution	1080p at 60 fps
Zoom	12x optical zoom
Codec	H.264
Network Protocols	SIP
Power Consumption	300W
Weight	90 kg