EasyManua.ls Logo

Cisco Telepresence MX800 - Conference Call Management

Cisco Telepresence MX800
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Start up the system
78-100574-02A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Installation guide for Cisco TelePresence MX800 Dual - Floor stand
Page 26
Remove the protection foil from the displays.
Make sure the cameras can move freely.
Insert the network and power cables into the wall outlets.
Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up may
include automatic software upgrade and restart of Touch 10 and
cameras.
Follow the instructions on the Touch controller.
Cisco Spark: To find more information on how to get started with
Spark registered systems, visit http://help.ciscospark.com and
look for Getting Started articles for room systems.
Other services: For further information on set-up and
configuration, download the Getting Started Guide from the
Cisco web site, http://www.cisco.com/go/mx-docs

Other manuals for Cisco Telepresence MX800

Related product manuals