Cisco UCS B200 M3 User Manual

Cisco UCS B200 M3 Blade Server
SUPPLEMENTAL MATERIAL
49
Network Connectivity
This section explains how the UCS B200 M3 server connects to Fabric Interconnects using the network
adapters in the UCS B200 M3 blade server and the Fabric Extender modules in the UCS 5108 blade server
chassis. The UCS B200 M3 server plugs into the front of the UCS 5108 blade server chassis. The Fabric
Extender modules plug into the back of the UCS 5108 series blade server chassis. A midplane connects the
UCS B200 M3 blade server to the Fabric Extenders.
Figure 8 shows an example configuration where 2 x 10G
KR ports are routed from the VIC 1240 adapter to the Fabric Extender modules and the remaining 2 x 10G
KR ports are routed from the mezzanine adapter to the Fabric Extender modules.
Figure 8 UCS B200 M3 Connections to the Fabric Extenders
The server accommodates two types of network adapters. One is the Cisco VIC 1240 adapter. The other is a
Cisco adapter, Emulex or QLogic I/O adapter, or Cisco Storage Accelerator adapter. The VIC 1240 is the only
adapter that can be used in the VIC 1240 slot. All other types of adapters plug into the mezzanine slot.

Cisco UCS B200 M3 Specifications

General

System bus rate	8 GT/s
Processor family	Intel
Processor socket	LGA 2011 (Socket R)
Intel Xeon series	E5-2600
Motherboard chipset	Intel C600
Compatible processor series	Intel® Xeon®
Number of processors supported	2
ECC	Yes
Memory form factor	240-pin DIMM
Number of DIMM slots	24
Supported memory types	DDR3-SDRAM
Maximum internal memory	768 GB
RAID levels	0, 1
Storage drive sizes supported	2.5 \
Supported storage drive interfaces	Serial Attached SCSI (SAS), Serial ATA III
USB 2.0 ports quantity	0
On-board graphics card model	Matrox G200
Chassis type	-
Product color	Silver
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	5 - 93 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	620 mm
Width	203 mm
Height	50 mm
Weight	4360 g