Cisco UCS B200 M3 User Manual

Cisco UCS B200 M3 Blade Server
CONFIGURING the SERVER
7
CONFIGURING the SERVER
Follow these steps to configure the Cisco UCS B200 M3 Blade Server:
■ STEP 1 VERIFY SERVER SKU, page 8
■ STEP 2 CHOOSE CPU(S), page 9
■ STEP 3 CHOOSE MEMORY, page 12
■ STEP 4 CHOOSE HARD DISK DRIVES or SOLID STATE DRIVES (OPTIONAL), page 18
■ STEP 5 CHOOSE ADAPTERS, page 20
■ STEP 6 ORDER A TRUSTED PLATFORM MODULE, page 23
■ STEP 7 ORDER CISCO FLEXIBLE FLASH SECURE DIGITAL CARDS, page 24
■ STEP 8 ORDER OPTIONAL INTERNAL USB 2.0 DRIVE, page 25
■ STEP 9 CHOOSE OPERATING SYSTEM AND VALUE-ADDED SOFTWARE, page 26
■ STEP 10 CHOOSE OPERATING SYSTEM MEDIA KIT, page 29
■ STEP 11 CHOOSE SERVICE and SUPPORT LEVEL, page 30

Cisco UCS B200 M3 Specifications

General

System bus rate	8 GT/s
Processor family	Intel
Processor socket	LGA 2011 (Socket R)
Intel Xeon series	E5-2600
Motherboard chipset	Intel C600
Compatible processor series	Intel® Xeon®
Number of processors supported	2
ECC	Yes
Memory form factor	240-pin DIMM
Number of DIMM slots	24
Supported memory types	DDR3-SDRAM
Maximum internal memory	768 GB
RAID levels	0, 1
Storage drive sizes supported	2.5 \
Supported storage drive interfaces	Serial Attached SCSI (SAS), Serial ATA III
USB 2.0 ports quantity	0
On-board graphics card model	Matrox G200
Chassis type	-
Product color	Silver
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	5 - 93 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	620 mm
Width	203 mm
Height	50 mm
Weight	4360 g