Cisco UCS B200 M3 User Manual

Cisco UCS B200 M3 Blade Server
SUPPLEMENTAL MATERIAL
53
In Figure 11, two ports from the VIC 1240 are channeled to 2208XP Fabric Extender A and two are
channeled to 2208XP Fabric Extender B. The Port Expander Card for VIC 1240 installed in the mezzanine slot
acts as a pass-through device to channel two ports to each of the Fabric Extenders. The result is 40 Gbps of
bandwidth to each Fabric Extender.
Figure 11 Option 2 - VIC 1240 and Port Expander Card for VIC 1240 to UCS 2208XP Fabric Extender
Connectivity using the Cisco UCS 2204XP Fabric Extender
The Cisco UCS 2204XP is a second-generation Fabric Extender, and shares the same form factor as the
current UCS 2100 series. The 2204XP is backwards compatible with the UCS 5108 Blade serve chassis.
The options shown in Figure 12 and Figure 13 demonstrate how the server uses these options:
■ VIC 1240 to 2204XP
■ VIC 1240 plus Port Expander Card for VIC 1240 to 2204XP
In Figure 12, one port from the VIC 1240 is channeled to 2204XP Fabric Extender A and one is channeled to
2204XP Fabric Extender B. The result is 10 Gbps of bandwidth to each Fabric Extender.

Cisco UCS B200 M3 Specifications

General

System bus rate	8 GT/s
Processor family	Intel
Processor socket	LGA 2011 (Socket R)
Intel Xeon series	E5-2600
Motherboard chipset	Intel C600
Compatible processor series	Intel® Xeon®
Number of processors supported	2
ECC	Yes
Memory form factor	240-pin DIMM
Number of DIMM slots	24
Supported memory types	DDR3-SDRAM
Maximum internal memory	768 GB
RAID levels	0, 1
Storage drive sizes supported	2.5 \
Supported storage drive interfaces	Serial Attached SCSI (SAS), Serial ATA III
USB 2.0 ports quantity	0
On-board graphics card model	Matrox G200
Chassis type	-
Product color	Silver
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	5 - 93 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	620 mm
Width	203 mm
Height	50 mm
Weight	4360 g