Cisco UCS X9508 - LEDs

• Each rail extends to fit the depth of the rack. The rails are not a sliding shelf that allow pulling the chassis
out of the rack to gain access to the chassis' sides.
• Each rail kit can fit into either a 9.5 mm square hole equipment rack or a 7.1 mm round-hole equipment
rack.
Some racks might be tapped, with threaded holes drilled directly into the rack's
sheetmetal instead of square- or round-hole punchouts for cage nuts. The rail kit
for the server is not currently supported in tapped (threaded hole) racks. Do not
attempt to install the chassis in a tapped (threaded-hole) equipment rack.
Caution
The rails are shipped in the accessory kit with each chassis, and each rail kit will contain a left and right side
as a matched pair. Both sides must be installed in the rack to securely support the chassis.
If you ordered multiple UCS X9508 chassis, you might receive both types of rail kit. For example, in a shipment
of 4 chassis, the shipment might have all one type of rail kit, or a few chassis with each type of rail kit.
Compare the two types of rail kits:
Installation
18
Installation
Rail Kits