Contents
x
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Configuring the Inaccessible Authentication Bypass Feature 9-33
Configuring IEEE 802.1x Authentication with WoL 9-35
Configuring MAC Authentication Bypass 9-36
Configuring NAC Layer 2 IEEE 802.1x Validation 9-37
Configuring Web Authentication 9-38
Disabling IEEE 802.1x Authentication on the Port 9-40
Resetting the IEEE 802.1x Authentication Configuration to the Default Values 9-41
Displaying IEEE 802.1x Statistics and Status 9-41
CHAPTER
10 Configuring Interface Characteristics 10-1
Understanding Interface Types 10-1
Port-Based VLANs 10-2
Switch Ports 10-2
Access Ports 10-2
Trunk Ports 10-3
EtherChannel Port Groups 10-3
Dual-Purpose Uplink Ports 10-4
Connecting Interfaces 10-4
Using Interface Configuration Mode 10-4
Procedures for Configuring Interfaces 10-5
Configuring a Range of Interfaces 10-6
Configuring and Using Interface Range Macros 10-7
Configuring Ethernet Interfaces 10-9
Default Ethernet Interface Configuration 10-9
Setting the Type of a Dual-Purpose Uplink Port 10-10
Configuring Interface Speed and Duplex Mode 10-12
Speed and Duplex Configuration Guidelines 10-12
Setting the Interface Speed and Duplex Parameters 10-13
Configuring IEEE 802.3x Flow Control 10-14
Configuring Auto-MDIX on an Interface 10-15
Adding a Description for an Interface 10-16
Configuring the System MTU 10-16
Monitoring and Maintaining the Interfaces 10-18
Monitoring Interface Status 10-18
Clearing and Resetting Interfaces and Counters 10-19
Shutting Down and Restarting the Interface 10-19
CHAPTER
11 Configuring Smartports Macros 11-1
Understanding Smartports Macros 11-1
To Next Page
Loading...
Need help?
General
