Cisco WS-C2960-24LC-S - Page 706

Index
IN-12
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
IGMP profile
applying
18-25
configuration mode 18-24
configuring 18-25
IGMP snooping
and address aliasing
18-2
configuring 18-6
default configuration 18-6, 30-5, 30-6
definition 18-1
enabling and disabling 18-7, 30-6
global configuration 18-7
Immediate Leave 18-5
method 18-8
monitoring 18-15, 30-11
querier
configuration guidelines
18-14
configuring 18-14
supported versions 18-2
support for 1-3
VLAN configuration 18-7
IGMP throttling
configuring
18-27
default configuration 18-24
described 18-24
displaying action 18-28
Immediate Leave, IGMP 18-5
enabling 30-9
inaccessible authentication bypass 9-13
initial configuration
defaults
1-10
Express Setup 1-2
See also getting started guide and hardware
installation guide
interface
number
10-5
range macros 10-7
interface command 10-5
interface configuration mode 2-3
interfaces
auto-MDIX, configuring
10-15
configuration guidelines
duplex and speed
10-12
configuring
procedure
10-5
counters, clearing 10-19
default configuration 10-9
described 10-16
descriptive name, adding 10-16
displaying information about 10-18
flow control 10-14
management 1-3
monitoring 10-18
naming 10-16
physical, identifying 10-5
range of 10-6
restarting 10-19
shutting down 10-19
speed and duplex, configuring 10-13
status 10-18
supported 10-4
types of 10-1
interfaces range macro command 10-7
interface types 10-5
Internet Protocol version 6
See IPv6
Intrusion Detection System
See IDS appliances
inventory management TLV
21-3, 21-6
IP ACLs
for QoS classification
28-7
IP addresses
128-bit
29-2
candidate or member 5-3, 5-12
cluster access 5-2
command switch 5-3, 5-10, 5-12
discovering 6-26
IPv6 29-2