Cisco WS-C2960-24LC-S - Page 707

Index
IN-13
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
IP addresses (continued)
redundant clusters
5-10
standby command switch 5-10, 5-12
See also IP information
ip igmp profile command
18-24
IP information
assigned
manually
3-10
through DHCP-based autoconfiguration 3-3
default configuration 3-3
IP phones
and QoS
14-1
automatic classification and queueing 28-19
configuring 14-4
ensuring port security with QoS 28-36
trusted boundary for QoS 28-36
IP precedence 28-2
IP-precedence-to-DSCP map for QoS 28-53
IP Service Level Agreements
See IP SLAs
IP service levels, analyzing
27-1
IP SLAs
benefits
27-2
configuration guidelines 27-5
Control Protocol 27-3
default configuration 27-5
definition 27-1
measuring network performance 27-2
monitoring 27-7
operation 27-3
responder
described
27-3
enabling 27-6
response time 27-4
SNMP support 27-2
supported metrics 27-2
IP traceroute
executing
32-16
overview 32-15
IPv4 and IPv6
differences
29-2
dual protocol stacks 29-5
IPv6
addresses
29-2
address formats 29-2
advantages 29-2
applications 29-5
autoconfiguration 29-4
configuring static routes 29-9
default configuration 29-8
defined 29-1
ICMP 29-4
ICMP rate limiting 29-8
monitoring 29-11
neighbor discovery 29-4
reasons for 29-1
SDM templates 29-6, 30-1
supported features 29-3
J
join messages, IGMP 18-3
L
LACP
See EtherChannel
Layer 2 frames, classification with CoS
28-2
Layer 2 interfaces, default configuration 10-9
Layer 2 traceroute
and ARP
32-15
and CDP 32-14
broadcast traffic 32-14
described 32-14
IP addresses and subnets 32-15
MAC addresses and VLANs 32-15
multicast traffic 32-15