Cisco WS-C2960-24LC-S - Page 708

Index
IN-14
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Layer 2 traceroute (continued)
multiple devices on a port
32-15
unicast traffic 32-14
usage guidelines 32-14
Layer 3 packets, classification methods 28-2
LDAP 4-2
LEDs, switch
See hardware installation guide
lightweight directory access protocol
See LDAP
line configuration mode
2-3
Link Aggregation Control Protocol
See EtherChannel
link failure, detecting unidirectional
16-8
Link Layer Discovery Protocol
See CDP
link local unicast addresses
29-3
links, unidirectional 22-1
link-state tracking
configuring
31-19
described 31-17
LLDP
configuring
21-3
characteristics 21-4
default configuration 21-3
disabling and enabling
globally
21-5
on an interface 21-5
monitoring and maintaining 21-7
overview 21-1
supported TLVs 21-2
switch stack considerations 21-2
transmission timer and holdtime, setting 21-4
LLDP-MED
configuring
procedures
21-3
TLVs 21-6
monitoring and maintaining 21-7
LLDP-MED (continued)
overview
21-1, 21-2
supported TLVs 21-2
LLDP Media Endpoint Discovery
See LLDP-MED
local SPAN
23-2
location TLV 21-3, 21-6
login authentication
with RADIUS
8-23
with TACACS+ 8-14
login banners 6-17
log messages
See system message logging
Long-Reach Ethernet (LRE) technology
1-14
loop guard
described
17-9
enabling 17-15
support for 1-6
LRE profiles, considerations in switch clusters 5-14
M
MAC/PHY configuration status TLV 21-2
MAC addresses
aging time
6-21
and VLAN association 6-20
building the address table 6-20
default configuration 6-21
discovering 6-26
displaying 6-26
dynamic
learning
6-20
removing 6-22
static
adding
6-24
allowing 6-25
characteristics of 6-24
dropping 6-25
removing 6-24