Cisco WS-C3020 - Configuring the Switch SDM Template; Default SDM Template

6-3
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Chapter 6 Configuring SDM Templates
Configuring the Switch SDM Template
Note Although these features are visible in the template in the CLI, the switch does not support IPv4 or IPv6
policy-based routing or IPv6 Qos ACLs.
Configuring the Switch SDM Template
These sections contain this configuration information:
• Default SDM Template, page 6-3
• SDM Template Configuration Guidelines, page 6-4
• Setting the SDM Template, page 6-4
Default SDM Template
The default template is the default.
Table 6-2 Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates
Resource
IPv4-and-IPv6
Default
IPv4-and-IPv6
Routing
IPv4-and-IPv6
VLAN
Unicast MAC addresses 2 K 1.5 K 8 K
IPv4 IGMP groups and multicast routes 1 K 1K 1 K
Total IPv4 unicast routes: 3 K 2.75 K 0
• Directly connected IPv4 hosts 2 K 1.5 K 0
• Indirect IPv4 routes 1 K 1.25 K 0
IPv6 multicast groups 1.125 K 1.125 K 1.125 K
Total IPv6 unicast routes: 3 K 2.75 K 0
• Directly connected IPv6 addresses 2 K 1.5 K 0
• Indirect IPv6 unicast routes 1 K 1.25 K 0
IPv4 policy-based routing ACEs
1
1. Not supported in the IP base image that runs on the switch.
0 0.25 K 0
IPv4 or MAC QoS ACEs (total) 0.75 K 0.75 K 0.75 K
IPv4 or MAC security ACEs (total) 1 K 0.5 K 1K
IPv6 policy-based routing ACEs
1
0 0.25 K 0
IPv6 QoS ACEs
1
0.5 K 0.5 K 0.5 K
IPv6 security ACEs
2
2. The switch supports only input IPv6 router ACLs for management traffic.
0.5 K 0.5 K 0.5 K