1-12
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• IEEE 802.1Q tunneling and Layer 2 protocol tunneling are disabled. For more information, see
Chapter 15, “Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling.”
• STP, PVST+ is enabled on VLAN 1. For more information, see Chapter 16, “Configuring STP.”
• MSTP is disabled. For more information, see Chapter 17, “Configuring MSTP.”
• Optional spanning-tree features are disabled. For more information, see Chapter 18, “Configuring
Optional Spanning-Tree Features.”
• Flex Links are not configured. For more information, see Chapter 19, “Configuring Flex Links and
the MAC Address-Table Move Update Feature.”
• DHCP snooping is disabled. The DHCP snooping information option is enabled. For more
information, see Chapter 20, “Configuring DHCP Features and IP Source Guard.”
• IP source guard is disabled. For more information, see Chapter 20, “Configuring DHCP Features
and IP Source Guard.”
• Dynamic ARP inspection is disabled on all VLANs. For more information, see Chapter 21,
“Configuring Dynamic ARP Inspection.”
• IGMP snooping is enabled. No IGMP filters are applied. For more information, see Chapter 22,
“Configuring IGMP Snooping and MVR.”
• IGMP throttling setting is deny. For more information, see Chapter 22, “Configuring IGMP
Snooping and MVR.”
• The IGMP snooping querier feature is disabled. For more information, see Chapter 22, “Configuring
IGMP Snooping and MVR.”
• MVR is disabled. For more information, see Chapter 22, “Configuring IGMP Snooping and MVR.”
• Port-based traffic
–
Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 23, “Configuring Port-Based Traffic Control.”
–
No protected ports are defined. For more information, see Chapter 23, “Configuring Port-Based
Traffic Control.”
–
Unicast and multicast traffic flooding is not blocked. For more information, see Chapter 23,
“Configuring Port-Based Traffic Control.”
–
No secure ports are configured. For more information, see Chapter 23, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 24, “Configuring CDP.”
• UDLD is disabled. For more information, see Chapter 26, “Configuring UDLD.”
• SPAN and RSPAN are disabled. For more information, see Chapter 27, “Configuring SPAN and
RSPAN.”
• RMON is disabled. For more information, see Chapter 28, “Configuring RMON.”
• Syslog messages are enabled and appear on the console. For more information, see Chapter 29,
“Configuring System Message Logging.”
• SNMP is enabled (Version 1). For more information, see Chapter 30, “Configuring SNMP.”
• No ACLs are configured. For more information, see Chapter 31, “Configuring Network Security
with ACLs.”
To Next Page
Loading...
