Index
IN-16
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
initial configuration
defaults
1-10
Express Setup 1-2
See also getting started guide and hardware
installation guide
interface
number
9-8
interface command 9-7 to 9-8
interface configuration mode 2-3
interface range macros 9-10
interfaces
auto-MDIX, configuring
9-18
configuration guidelines
duplex and speed
9-15
configuring
procedure
9-8
counters, clearing 9-23
default configuration 9-12
described 9-19
descriptive name, adding 9-19
displaying information about 9-23
flow control 9-17
management 1-3
monitoring 9-22
naming 9-19
physical, identifying 9-7
range of 9-9
restarting 9-24
shutting down 9-24
speed and duplex, configuring 9-16
status 9-22
supported 9-7
types of 9-1
interfaces range macro command 9-10
interface types 9-7
Internet Control Message Protocol
See ICMP
Internet Protocol version 6
See IPv6
Inter-Switch Link
See ISL
inter-VLAN routing
1-9, 34-2
Intrusion Detection System
See IDS appliances
inventory-management TLV
25-6
IP ACLs
for QoS classification
32-7
implicit deny 31-9, 31-13
implicit masks 31-9
named 31-14
undefined 31-20
IP addresses
128-bit
35-2
classes of 34-5
default configuration 34-4
discovering 5-27
for IP routing 34-3
IPv6 35-2
MAC address association 34-7
monitoring 34-16
IP base image 1-1
IP broadcast address 34-14
ip cef distributed command 34-28
IP directed broadcasts 34-12
ip igmp profile command 22-25
IP information
assigned
manually
3-14
through DHCP-based autoconfiguration 3-3
default configuration 3-3
IP multicast routing and IGMP snooping 22-2
IP phones
and QoS
13-1
automatic classification and queueing 32-20
configuring 13-4
ensuring port security with QoS 32-38
trusted boundary for QoS 32-38
IP precedence 32-2
To Next Page