Index
IN-18
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
IP unicast routing (continued)
default
addressing configuration
34-4
gateways 34-10
networks 34-31
routes 34-31
routing 34-2
directed broadcasts 34-12
disabling 34-17
dynamic routing 34-2
enabling 34-17
EtherChannel Layer 3 interface 34-3
inter-VLAN 34-2
IP addressing
classes
34-5
configuring 34-3
IRDP 34-11
Layer 3 interfaces 34-3
MAC address and IP address 34-7
passive interfaces 34-34
protocols, distance-vector 34-2
proxy ARP 34-7
redistribution 34-31
reverse address resolution 34-7
routed ports 34-3
static routing 34-2
steps to configure 34-3
subnet mask 34-5
subnet zero 34-5
supernet 34-6
UDP 34-14
with SVIs 34-3
See also EIGRP
See also RIP
IPv4 ACLs
applying to interfaces
31-19
extended, creating 31-10
named 31-14
standard, creating 31-9
IPv4 and IPv6
differences
35-2
dual protocol stacks 35-10
IPv6
ACLs
displaying
37-7
limitations 37-2
matching criteria 37-2
port 37-1
router 37-1
supported 37-2
addresses 35-2
address formats 35-2
advantages 35-2
applications 35-9
assigning address 35-14
autoconfiguration 35-4
autogenerated address 35-6
configuring static routes 35-16
default configuration 35-13
defined 35-1
duplicate-address detection 35-5
enabling 35-14
global prefixes 35-5
ICMP 35-4
ICMP rate limiting 35-15
link-local address 35-5
monitoring 35-18
neighbor discovery 35-4
reasons for 35-1
router advertisement messages 35-5
router advertisements 35-5
SDM templates 6-2, 35-12, 36-1, 36-6, 37-1
Stateless Autoconfiguration 35-4
supported features 35-3
IPv6 traffic, filtering 37-3
To Next Page