Index
IN-20
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Layer 3 packets, classification methods 32-2
LDAP 4-2
LEDs, switch
See hardware installation guide
lightweight directory access protocol
See LDAP
line configuration mode
2-3
Link Aggregation Control Protocol
See EtherChannel
Link Failure
detecting unidirectional
17-8
Link Layer Discovery Protocol
See CDP
link local unicast addresses
35-3
link redundancy
See Flex Links
links, unidirectional
26-1
LLDP
configuring
25-3
characteristics 25-4
default configuration 25-3
disabling and enabling
globally
25-5
on an interface 25-5
monitoring and maintaining 25-7
overview 25-1
supported tlvs 25-2
transmission timer and holdtime, setting 25-4
LLDP-MED
configuring
25-3
tlvs 25-6
monitoring and maintaining 25-7
overview 25-1, 25-2
supported tlvs 25-2
LLDP Media Endpoint Discovery
See LLDP-MED
load balancing
38-3
local SPAN 27-2
location TLV 25-2, 25-6
logging messages, ACL 31-8
login authentication
with RADIUS
7-23
with TACACS+ 7-14
login banners 5-17
log messages
See system message logging
loop guard
described
18-9
enabling 18-15
support for 1-5
M
MAB aging timer 1-6
MAB inactivity timer
default setting
8-21
range 8-24
MAC addresses
aging time
5-21
and VLAN association 5-20
building the address table 5-20
default configuration 5-21
discovering 5-27
displaying 5-26
displaying in the IP source binding table 20-18
dynamic
learning
5-20
removing 5-22
in ACLs 31-26
IP address association 34-7
static
adding
5-24
allowing 5-26
characteristics of 5-24
dropping 5-25
removing 5-24
MAC address notification, support for 1-10