Index
IN-35
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
SNMP (continued)
MIBs
location of
A-3
supported A-1
notifications 30-5
overview 30-1, 30-4
security levels 30-3
status, displaying 30-17
system contact and location 30-14
trap manager, configuring 30-13
traps
described
30-3, 30-5
differences from informs 30-5
disabling 30-14
enabling 30-11
enabling MAC address notification 5-22
overview 30-1, 30-4
types of 30-11
users 30-6, 30-9
versions supported 30-2
SNMP and Syslog Over IPv6 35-10
SNMPv1 30-2
SNMPv2C 30-2
SNMPv3 30-2
snooping, IGMP 22-2
software images
location in flash
B-24
recovery procedures 40-2
scheduling reloads 3-22
tar file format, described B-24
See also downloading and uploading
source addresses
in IPv6 ACLs
37-4
source addresses, in IPv4 ACLs 31-11
source-and-destination-IP address based forwarding,
EtherChannel
33-7
source-and-destination MAC address forwarding,
EtherChannel
33-6
source-IP address based forwarding, EtherChannel 33-7
source-MAC address forwarding, EtherChannel 33-6
SPAN
configuration guidelines
27-10
default configuration 27-9
destination ports 27-7
displaying status 27-23
interaction with other features 27-8
monitored ports 27-5
monitoring ports 27-7
overview 1-10, 27-1
ports, restrictions 23-12
received traffic 27-4
sessions
configuring ingress forwarding
27-14, 27-21
creating 27-11
defined 27-3
limiting source traffic to specific VLANs 27-14
removing destination (monitoring) ports 27-12
specifying monitored ports 27-11
with ingress traffic enabled 27-13
source ports 27-5
transmitted traffic 27-5
VLAN-based 27-6
spanning tree and native VLANs 11-19
Spanning Tree Protocol
See STP
SPAN traffic
27-4
split horizon, RIP 34-21
SRR
configuring
shaped weights on egress queues
32-75
shared weights on egress queues 32-76
shared weights on ingress queues 32-68
described 32-14
shaped mode 32-14
shared mode 32-14
support for 1-9
To Next Page