Cisco WS-C3020 - Page 954

Index
IN-38
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
STP (continued)
root switch
configuring
16-14
effects of extended system ID 16-4, 16-14
election 16-3
unexpected behavior 16-14
shutdown Port Fast-enabled port 18-2
status, displaying 16-22
superior BPDU 16-3
timers, described 16-20
UplinkFast
described
18-3
enabling 18-13
stratum, NTP 5-2
stub routing
EIGRP
34-26
PIM 34-24
subdomains, private VLAN 14-1
subnet mask 34-5
subnet zero 34-5
success response, VMPS 11-28
summer time 5-13
SunNet Manager 1-3
supernet 34-6
SVIs
and IP unicast routing
34-3
and router ACLs 31-4
connecting VLANs 9-6
defined 9-5
routing between VLANs 11-2
switch console port 1-5
Switch Database Management
See SDM
switched packets, ACLs on
31-37
Switched Port Analyzer
See SPAN
switched ports
9-2
switchport block multicast command 23-8
switchport block unicast command 23-8
switchport command 9-12
switchport mode dot1q-tunnel command 15-6
switchport protected command 23-7
switch priority
MSTP
17-21
STP 16-19
switch software features 1-1
switch virtual interface
See SVI
syslog
See system message logging
Syslog Over IPv6
35-11
system clock
configuring
daylight saving time
5-13
manually 5-11
summer time 5-13
time zones 5-12
displaying the time and date 5-12
overview 5-1
See also NTP
system message logging
default configuration
29-3
defining error message severity levels 29-8
disabling 29-4
displaying the configuration 29-13
enabling 29-4
facility keywords, described 29-13
level keywords, described 29-9
limiting messages 29-10
message format 29-2
overview 29-1
sequence numbers, enabling and disabling 29-8
setting the display destination device 29-5
synchronizing log messages 29-6
syslog facility 1-10
time stamps, enabling and disabling 29-7