Cisco WS-C3560-48PS-S - Page 119

Index
IN-5
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
24- and 48-port switches 2-7, 2-11
8- and 12-port switches 3-16, 3-17
rear panel
clearance
2-5, 3-5
description 1-15 to 1-19
removing SFP modules 2-17 to 2-18
restricted access area warning C-1
RJ-45 connector, console port B-3
RPS
connecting to
2-6, 3-7
connector 1-19
LED 1-12
S
safety warnings (24- and 48-port switches) 2-2, 3-2
security slot 1-20
serial number location 4-6
servicing equipment warning C-5
SFP module patch cable
description
1-10
installing and removing 2-18
SFP modules
1000BASE-T supported speeds
1-14
bale-clasp latch removal 2-17
cable specifications B-4
connecting to 2-21 to 2-23
connectors B-2
described 1-10
installation 2-16 to 2-17
shelf-mounting
24- and 48-port switches
2-15
8- and 12-port switches 3-8
Simple Network Management Protocol
See SNMP
SNMP network management platforms
1-21
software switch management 1-20
speed, troubleshooting 4-4
straight-through cable pinout
four twisted-pair 1000BASE-T ports
B-6
two twisted-pair 10/100 ports B-5
SunNet Manager 1-21
Switch models illustrated 1-3
switch powering on 2-6, 3-7
T
Telnet, and accessing the CLI 1-21
terminal block wires caution C-7
terminal emulation software D-2
torquing the terminal block caution C-6
troubleshooting 4-1 to 4-6
bad or damaged cable 4-2
connection problems 4-2
diagnosing problems 4-1
Ethernet and fiber-optic cables 4-3
link status 4-3
ping end device 4-4
port and interface settings 4-4
POST 4-1
spanning tree loops 4-4
speed, duplex, and autonegotiation 4-4
switch performance 4-4
troubleshooting spanning tree loops 4-4
W
wall-mounting
24- and 48-port switches
2-12
8- and 12-port switches 3-17
warnings
code compliance
2-4, 3-4
DC power C-6
defined i-vii
ground connection C-2
installation (24- and 48-port switches) 2-2
installation (8- and 12-port switches) 3-2