Citizen CLP-7202e - Configuration of Approved Media (When Using Adjustable Sensor)

Chapter 3 Media and Ribbon 

40
3 Configuration of Approved Media
(When Using Adjustable Sensor)
The adjustable sensor is the standard for CLP-7201e but it is the optional for CLP-7202e.
Make sure that the adjustable sensor is set to ‘AJSensON.’ (See Chapter 2.)
Minimum value mm (in) Maximum value mm (in)
A Label width 25.24 (1.0) 118.00 (4.65)
B Liner width 25.24 (1.0) 118.00 (4.65)
C Left end of label 0 2.54 (0.10)
D Gap between labels 2.54 (0.10) 2539.00 (99.96)
E Label length 12.70 (0.50) 2539.00 (99.96)
F Label pitch 12.70 (0.50) 2539.00 (99.96)
G Liner thickness 0.05 (0.0025) 0.125 (0.0049)
H Media thickness 0.05 (0.0025) 0.25 (0.01)
I Right end of notch  3.6 (0.14)  60.8 (2.39)
J Left end of notch 0  57.2 (2.25)
K Notch length 2.54 (0.10) 17.80 (0.70)
L Right end of black mark 15.00 (0.59)  66.5 (2.62)
M Left end of black mark 0  51.5 (2.02)
N Black mark width 3.18 (0.125) 17.80 (0.70)
Note: • Media having both gaps between labels and black marks should use the media gap sensor.
• Fanfold media should use the media gap sensor.
Size of media
Labels
Continuous media
Notch detection Black mark
Printable
area
Black mark
OD value: 1.5 or
more
Carbon black ink
Label
Label
Label
Use of media gap
sensor
Use of media gap
sensor
Use of black mark
sensor
Direction of media feed
2.5mm 104.0mm (11.5mm)
Left mar
g
in Printable area Ri
g
ht
Printable area
3 Configuration of Approved Media (When Using Adjustable Sensor)