EasyManua.ls Logo

Citizen CLP-7202e - Error Messages

Citizen CLP-7202e
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5 Troubleshooting
56
1 Error Messages
When there is a problem with the printer:
- A buzzer sounds.
- The error indicator lights up.
- An error message is shown on the LCD screen.
Errors and corrective actions are shown below.
1 Errors indications
Description Indication LED Buzzer
Printhead temperature low ColdHead Lights Sounds long
PCB temperature low Cold PCB Lights Sounds long
Printhead resistance value abnormal (error contents
and printhead information repeatedly displayed)
Rank: Rank of printhead resistance value
Average: Average of resistance values (A/D
reading value in decimal system)
Maximum: Max. resistance value
Minimum: Min. resistance value
Head Err
Rank ***
Ave.***
Max.***
Min.***
Lights Sounds long
Communication error (receive buffer overrun) OverFlow Lights Sounds long
Communication error (parity, framing) S/I Err Lights Sounds long
Communication error (transmit buffer overflow) HostBusy
T.D.Full
Blinks Sounds short 3 times
Pause key pressed Pause
Pause command reception (remote control) Pause
Printhead overheat OverHeat
Cooling
Blinks Sounds short 3 times
Stop key pressed Stop Sounds short 3 times
Stop command reception (remote control) Cancel
Printhead mechanism open HeadOpen Lights Sounds short 3 times
Paper end (paper out) PaperEnd Lights Sounds short 3 times
Paper out (paper position cannot be detected) (error
contents and sensor information repeatedly
displayed)
M command: Sets length for detection miss
checking with system command M
Maximum: Max. value of sensor reading voltage
Minimum: Min. value of sensor reading voltage
PaperErr
M CMMD
Max*.**V
Min*.**V
Lights Sounds short 3 times
Ribbon end RibonOut Lights Sounds short 3 times
PCB overheat
(PCB or sensor abnormal)
OverHeat Lights Sounds short 3 times
Fan stop Fan stop Blinks Sounds short 3 times
Option board abnormal OP Err Lights Sounds short 3 times
Auto-cutter abnormal(such as poor engagement) Cut Err Lights Sounds short 3 times
ROM checksum error ROM Err Lights Sounds long
RAM check error RAM Err Lights Sounds long
1 Error Messages

Related product manuals