Before Operation
6
Never perform the following. If not avoided, these may cause damage or trouble to the
printer or cause the printer to overheat and release smoke and cause burns or an
electrical shock. If the printer is damaged or is malfunctioning, be sure to turn the power off
immediately and remove the power cord from the outlet, then consult our service
personnel.
• Do not jolt or impact to the printer by stepping on, dropping or hitting the printer.
• Do not place the printer in a poorly ventilated area, or shut off the air vent of the
printer.
• Do not place the printer where chemical reactions occur, such as in laboratories or
where air is mixed with salt or gas.
• Do not use a power voltage or frequency other than those specified.
• Do not plug/unplug the power cord or attach/detach the interface cable by simply
grabbing the power cord or interface cable. Do not pull or carry the printer when the
tension of the power cord or interface cable is increased.
• Do not drop or put foreign matter such as clips and pins into the printer. This may
cause problems.
• Do not plug the power cord into an outlet with many loads.
• Do not spill drinks such as tea, coffee and juice on the printer or spray insecticide on
the printer. If drink or water is spilled, first be sure to turn the power off and remove the
power cord from the outlet, then consult our service personnel.
• Do not disassemble or modify the printer.
Discard or safely store the plastic packing bag. This bag should be kept away from
children. If the bag is pulled over a child’s head, it may cause suffocation.
WARNING
To Next Page
Loading...
Need help?
General
