Citizen CLP-7202e - Chapter 3 Media and Ribbon; Kinds of Approved Media; Configuration of Approved Media (When Using Front Sensors); Configuration of Approved Media (When Using Adjustable Sensor)

Chapter 2 Printer Operation

35
6 Returning to Factory Setting
To return all the contents already made in the printer configuration setting mode or system
maintenance mode to the factory setting, proceed as follows:
First turn OFF the power switch, then press and hold the PAUSE, FEED and STOP keys
simultaneously and at the same time turn ON the power switch, and continue holding down
those keys.

Factory setting
Printer configuration setting mode System maintenance mode
Item Indication Item Indication
Printing method Transfer Baud rate 9600bps
Operation after
printing
NoAction Data length 8 bits
Media sensor Edge Native NativeON
Print density Heat 10 Feed amount f Virtual
Printing speed Pspeed 6 Command code Cmnd STD
Feed speed Fspeed 7 Adjustable sensor AJSensOF
Back-feed speed Bspeed 4 Voltage setting PE *.**V
Print start position V 0.00in  
Column offset H 0.00in  
Media stop position S 0.00in  
Command
overriding
SetLckOF  
Turn ON the power switch while
holding down those keys
simultaneously
S/IInit
SMainte
A ‘Pi’ sound is heard. Continue
holding down those keys
When a ‘Pi’ sound is heard again,
the operation is completed
6 Returning to Factory Settin
g