Chapter 4 Printer Adjustments
51
(2) Easy-to-slip ribbon and media
If a message ‘RibonOut’ is shown, set the
mark on the feeding section to LOW by
turning the adjust-knob.
(3) Especially-easy-to-slip ribbon and
media
If a message ‘RibonOut’ is still shown,
although Step (2) has been performed, set the
mark on the feeding section to SUPER LOW
by turning the adjust-knob.
(4) When ribbon is broken during
printing
Ribbon may be broken if it is narrow in width
and printhead heat temperature is high. In
that case, set the mark on the feeding section
to SUPER LOW and set the mark on the
winding section to LOW by turning the adjust-
knob and adjust-screw respectively.
Note: If the problem is still not resolved,
please contact our service personnel.
Winding section
Feeding section
Winding section
Feeding section
Winding section
Feeding section
3 Use of Narrow Media/Ribbons (Ribbon Tension Adjustments)
To Next Page
Loading...
