Appendixes
74
6. Interface pin assignment
The serial and parallel pin assignment tables are shown below.
Serial interface pin assignment table
Pin No. Signal Input/Output Description
1 F.GND Output Frame ground
2 TXD Output RS-232C output data
3 RXD Input RS-232C input data
4 RTS Output RS-232C (pull up to +5V with 2 KΩ)
5 CTS Input RS-232C data transmission on computer
enabled
6 NC − Not connected
7 S.GND Output Signal ground
8 NC − Not connected
9 NC − Not connected
10 NC − Not connected
11 NC − Not connected
12 NC − Not connected
13 L.GND Output Control system ground
14 VCCs Output Control system power +5 V (max. service
current 0.05A)
15 NC − Not connected
16 NC − Not connected
17 NC − Not connected
18 NC − Not connected
19 NC − Not connected
20 DTR Output RS-232C printer data receiving enabled
21 NC − Not connected
22 NC − Not connected
23 NC − Not connected
24 NC − Not connected
25 NC − Not connected
2 Specifications
To Next Page
Loading...
