Citizen CT-E351 - Paper Detecting Commands; ESC C 3 N

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 146 -
2.2.8 Paper Detecting Commands
ESC c 3 n
[Function] Selecting the Paper Sensor valid for a Paper-end signal output
[Code] <1B>H<63>H<33>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is common to the model]
• This command selects by which Paper Sensor a Paper-end signal should be output. Each bit for “n” has the
following meaning:
Bit Position
Value
0
1
0
Paper Near-end
Disabled
Enabled
1
Paper Near-end
Disabled
Enabled
2
Paper-end
Disabled
Enabled
3
Paper-end
Disabled
Enabled
4
Undefined
—
—
5
Undefined
—
—
6
Undefined
—
—
7
Undefined
—
—
[Caution] [The specification which is common to the model]
• This command is valid only for the parallel interface.
[Default] [The specification which depend on the model]
CT-S280/CT-S281/CT-S300/CT-S310/CT-S2000/CT-S4000
n=15
CT-P29x series/CT-S301II/CT-D150/CT-E351
n=15 (no signal at paper near end due to no paper near end sensor.)
CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)/CT-S251/CT-D151/CT-E651
• MSW3-2 OFF: n=15
• MSW3-2 ON : n=12