Citizen CT-E351 - Page 222

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 221 -
CT-S4000
• Setting MSW 4 (a=4)
n
b (Set Value)
Function
1
48 (Default)
At the selection of Black mark paper/ label paper, enables
auto end-measurement.
49
At the selection of Black mark paper/ label paper, disables
auto end-measurement.
2
48 (Default)
Setting the first position at power ON disabled.
49
Setting the first position at power ON enabled.
3
48
Paper heading cut disabled.
49 (Default)
Paper heading cut enabled.
4
48 (Default)
Uses thermal roll paper.
49
Uses Black mark paper/ label paper.
5
48 (Default)
Detects paper position and black mark.
49
Detects paper position and inter-label distance.
6
48 (Default)
Reserved
7 48 (Default)
Reserved
8
48
Forcible partial cut disabled.
49 (Default)
Forcible partial cut enabled (full but by command:
enabled).
* Default setting of MSW4-4 depends on the model. Thermal paper is the
default of the standard model.
* MSW 4-5 is valid only for black mark/label model. If MSW4-4 is set for
thermal paper, it is invalid
* MSW4-8 is invalid when black mark/label is selected. Cut type for black
mark/label paper is only full cut.
• Setting MSW 5 (a=5)
n
b (Set Value)
Function
1
48 (Default)
Buzzer sound enabled.
49
Buzzer sound disabled.
2
48 (Default)
Basic calculation pitch (180 dpi / 360 dpi).
49
Basic calculation pitch (203 dpi / 406 dpi).
3
48
USB mode virtual serial.
49 (Default)
USB mode printer class.
4
48 (Default)
Reserved
5
48 (Default)
Reports the power off.
49
Does not report power off.
6
48 (Default)
Reserved
7
48 (Default)
Reserved
8
48 (Default)
Reserved