Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
- 223 -
CT-S801/CT-S851/CT-S601/CT-S601
• Setting MSW 4 (a=4)
1
48 (Default)
At the selection of Black mark/Label paper, disables auto
end-measurement.
49
At the selection of Black mark/Label paper, enables auto
end-measurement.
2
Finding top of form at power ON disabled.
Finding top of form at power ON enabled.
3
Feed & Cut at TOF disabled.
Feed & Cut at TOF enabled.
4
Uses Black mark paper/ label paper.
5
Detects paper position and black mark.
Detects paper position and inter-label distance.
6
Paper type selection disabled
Paper type selection enabled
8
Cut method is determined according to the cut command.
49 (Default)
Partial cut is performed regardless of cut command. (full
but by command: enabled).
* Default setting of MSW4-4 depends on the model. Thermal paper is the
default of the standard model.
* MSW 4-5 is valid only for black mark/label model. If MSW4-4 is set for
thermal paper, it is invalid
* MSW4-8 is invalid when black mark/label is selected. Cut type for black
mark/label paper is only full cut.
• Setting MSW 5 (a=5)
1
2
Basic calculation pitch (180 dpi / 360 dpi).
Basic calculation pitch (203 dpi / 406 dpi).
3
• Setting MSW 6 (a=6)
1
Act for driver is enabled.
Act for driver is disabled.
2
Character space is set for 0.
Character space is set for 1
To Next Page
Loading...
