Citizen CT-E351 - Page 229

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 228 -
CT-P29x series
• Setting MSW 1 (a=1)
n
b (Set Value)
Function
1
48 (Default)
Reports the power on.
49
Does not report power on.
2
48 (Default)
Sets input buffer capacity to 4K bytes.
49
Sets input buffer capacity to 45 bytes. (Note)
3
48 (Default)
Sets input buffer full and offline to be Busy.
49
Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
49
At the occurrence of receiving error, ignores the data.
5
48 (Default)
Disables CR (0DH).
49
Enables CR (0DH).
6
48 (Default)
Reserved
7
48 (Default)
Does not reset at serial I/F pin 6.
49
Resets at serial I/F pin 6.
8
48 (Default)
Reserved
• Setting MSW 2 (a=2)
n
b (Set Value)
Function
1
49 (Default)
Reserved
2
48 Disables auto cutter.
49(Default)
Enables auto cutter.
3
48 (Default)
Enables stored printing.
49
Disables stored printing.
4
48 (Default)
Immediately after digit reaches full, line-feed is taken.
49
Immediately after digit reaches full, data wait is taken.
5
48 (Default)
After head-down* and PE recovery, prints as it is.
49
After head-down* and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6
48
Sets paper width to 80 mm.
49
Sets paper width to 58(60) mm.
7
48 (Default)
Reserved
8
48
Enables PNE.
49 (Default)
Disables PNE.
• Setting MSW 3 (a=3)
n
b (Set Value)
Function
1
48 (Default)
After clearing cutter error, can be restored by Feed SW.
49
After clearing cutter error, cannot be restored by Feed SW.
2
48 (Default)
Reserved
3
48 (Default)
Resets with parallel pin 31.
49
Does not reset with parallel pin 31.
4
48 (Default)
Uses thermal paper.
49
Uses Black mark paper.
5
48(Default)
Used with 48 print columns
49
Used with 32 print columns.
6
48 (Default)
Reserved
7
48 (Default)
Sets EPSON compatible mode.
49
Sets CBM1000-compatible mode.
8
48 (Default)
Sets
platen-open
error during printing to be auto recovery
error.
49
Sets
platen-open
error during printing to be recoverable
error.