Citizen CT-E351 - Page 259

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 258 -
CT-S4000
• a=6: Sets printing speed to the value specified by (nL+nH×256).
(nL+nH×256)
Printing Speed
1
Printing speed level 1 (min)
2
Printing speed level 2
3
Printing speed level 3
4
Printing speed level 4
5
Printing speed level 5
6
Printing speed level 6
7
Printing speed level 7
8
Printing speed level 8
9(Default)
Printing speed level 9 (max)
• a=116: Sets the paper specified by (nL+nH×256).
(nL+nH×256)
Paper
1 (Default)
Specified single color paper.
257
Recommended 2-color paper5
• a=201: Outputs ACK to the position specified by (nL+nH×256).
(nL+nH×256)
ACK Output Position
1(Default)
ACK-in-Busy
2
ACK-while-Busy
3
ACK-after-Busy
• a=202: Controls input buffer full Busy with the value selected by
(nL+nH×256) and controls Busy with output/cancel timing
(remaining capacity).
(nL+nH×256)
When Input Buffer
Capacity “Small” is Set
When Input Buffer
Capacity 4K Bytes (Large)
is Set
Output
Cancel
Output
Cancel
1
16
26
128
256
2
16
40
128
512
3
30
50
72
256
4
30
60
72
512
• XON/XOFF is also output by the establishment of conditions.
• Ignores the data received when input buffer idle capacity is 0.
• a=212: Selects DMA (Direct Memory Access) control of serial
communication specified by (nL+nH×256).
(nL+nH×256)
DMA control
1
Invalid
2(Default)
Valid
• a=213: Selects the flow control specified by (nL+nH×256) when virtual
COM is set.
(nL+nH×256)
Flow control
1(Default)
PC setting
2
DTR/DSR
3
XON/XOFF