Citizen CT-E351 - Page 264

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 263 -
CT-S801(II)/CT-S851(II)
• a=222: Sets Sensor and distance between header with the value selected
by (nL+nH×256). [CT-S801(II), CT-S851]
0≤(nL+nH×256)≤32767
Unit: 168dot
Initial value: 144 dots
• a=223: Sets black mark bottom margin with the amount selected by
(nL+nH×256). [CT-S801(II), CT-S851]
0≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 0 dot
• a=224: Sets head margin with the value selected by (nL+nH×256).
[CT-S801(II), CT-S851]
0≤(nL+nH×256)≤ 32767
Unit: 1 dot
Initial value: 0 dot
• a=225: Sets the maximum width of mark with value selected by
(nL+nH×256). [CT-S801(II), CT-S851]
1≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 240 dots
• a=227: Sets max length of auto length measurement with the value
selected by (nL+nH×256). [CT-S801(II), CT-S851]
0≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 2560 dots
• a=228: Sets the after an auto cut movement with the value selected by
(nL+nH×256). [CT-S801II]
0≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 80 dots
• a=229: Sets the manual cut position with the value selected by
(nL+nH×256). [CT-S801II]
0≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 284 dots